Appendix B G1000 System Software & Configuration - Garmin G1000 NAV III Line Maintenance Manual

APPENDIX B G1000 SYSTEM SOFTWARE & CONFIGURATION
The following information is intended to serve as an example for a complete reconfiguration of the G1000
system. Software part numbers and software versions shown are not intended to be airframe specific. For
actual software versions and part number refer to Page i.
DO NOT ALLOW POWER TO BE REMOVED FROM THE SYSTEM WHEN LOADING
SOFTWARE! Connect a ground power unit to the aircraft for software loading. Do not rely
solely on the aircraft batteries to prevent loss of power during the software loading process. All
GDUs should be in the same mode (configuration or normal), unless instructed differently by the
procedure. Remove power only when instructed by the procedure.
Remove Supplemental Data Cards (010-00330-41 or 010-00330-42) from the lower slot of the
GDUs before loading any software. Supplemental Data Cards left inserted can become corrupt,
making them unusable. Replacing corrupt cards is not covered under warranty.
Refer to the Cessna Maintenance Manual for approved software versions and part numbers.
Garmin recommends the use of SanDisk or Toshiba SD cards to load G1000 software and
configuration files. If software loading problems occur when using another brand of card, replace
the card with a SanDisk or Toshiba card and reattempt the software load.
G1000 Nav III Line Maintenance Manual
190-00352-00
CAUTION
CAUTION
NOTE
NOTE
Page B-1
Rev. L