Commissioning; Installing The Software; Connecting The Plotter; Inserting/Replacing The Plotter Pen - Weidmuller MCP Basic 2 Operating Instructions Manual

5

Commissioning

5.1 Installing the software

The M-Print PRO operating software can be found on
®
the DVD provided.
► Install the software on the PC.
► Follow the instructions in the installation routine.
The software instructions can also be found
on the DVD provided.

5.2 Connecting the plotter

Possible danger to life!
The power pack has a variable AC input
voltage of 100–240 V AC / 50–60 Hz.
► Make sure that the mains connection
provided is suitable and in good
working condition.
► If necessary, replace the adapter on the mains plug
(for US or UK).
► Connect the mains connection cable to the plotter
(Fig. 4.1, number 10).
► Plug the mains connector into the socket.
► Connect the USB cable to the plotter (Fig. 4.1,
number 12) and connect it to the PC.
1168680000/02/12.2016
WARNING

5.3 Inserting/replacing the plotter pen

Only use the plotter pens specified as
accessories (see Chapter 10).
Fig. 5.1 Plotter pen
Follow the instructions provided with the
plotter pen.
► Test the plotter pen manually before you use it. Only
use a plastic surface for this purpose.
► Insert the plotter pen in the pen holder on the
lowering unit of the writing arm.
If the plotter was already switched on,
switch it off and back on again. This is the
only way to guarantee that the auto-calibration
process is effective.
27