Safety; Intended Use; Labelling Elements; Electrical Connection - Weidmuller MCP Basic 2 Operating Instructions Manual

2

Safety

2.1 Intended use

The MCP Basic 2 plotter is designed for the labelling
of markers or labels fitted to industrial systems.
The operation of the plotter is controlled by the
M-Print PRO software. It is designed for commercial
®
environments (offices).
The device is only intended for the application
described in the operating instructions with the
labelling elements described.
The device must not be opened. Repairs, including
replacing the power pack, must be carried out by a
qualified electrician.
Observance of the documentation is also
part of the intended use.

2.2 Labelling elements

The following materials can be labelled with the
MCP Basic 2:
– Markers in MultiCard format
– Labels

2.3 Electrical connection

The device can be operated in the 100–240 V AC /
50–60 Hz voltage ranges. The electrical connection
conditions must correspond to the information on the
type plate.

2.4 Operating personnel

These operating instructions have been written for
trained and qualified personnel who are familiar with
the valid regulations and standards applicable to the
field of application.

2.5 Conformity

The product complies with the following European
directives:
– Low Voltage Directive 2014/35/EU
– EMC Directive 2014/30/EU
1168680000/02/12.2016

2.6 Disposal/recycling

At the end of its service life, make sure the device is
disposed of in accordance with the local regulations.
You can also return the device to Weidmüller for proper
disposal. Simply send it by parcel service (in a box)
to the Weidmüller subsidiary that supports you. We
will then take care of all of the recycling and disposal
activities.
21