Table of Contents
Advertisement
AIR LINE
Use a ¼" air hose between the compressor and the tool. Compressed air is cooled and its water con-
tent separated, as the air leaves the compressor. A portion of water content, however, is condensed in
the piping and can enter the tool mechanism which might cause trouble. Install an air filter and an oiler
between the compressor and the tool. Use a 3 HP or larger compressor for each tool.
INSERTED TOOLS
Only use sockets or adapters which are in good working condition. The intended socket and adapter
for this air tool is stated as square drive included in the technical data table.
SAFETY
Wear proper eye protection, ear-muffs, mouth-muffle and gloves at all times when operating this
tool to minimize risks of injury.
The working place must be well ventilated.
Release the on/off switch in case of energy supply failure.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 21
Advertisement
Table of Contents
