Table of Contents
Advertisement
4) If you experience numbness, tingling, pain or whitening of the skin in your fingers or hands, stop
using the power tool, tell your employer and consult a physician.
5) Operate and maintain the power tool as recommended in the operation manual to prevent any un-
necessary increase in vibration levels.
6) Do not use worn or bad fitting sockets or extensions as this is likely to cause a substantial in-
crease in vibration. Always maintain the tool and its accessories to avoid unnecessary increase in
vibration levels.
7) Sleeve fittings should be used when practicable.
8) Support the weight of the tool in a stand, tensioner or balancer if possible.
9) Hold the tool with a light but safe grip, taking account of the required had reaction forces, because
the risk from vibration in generally greater when the grip force is higher.
ADDITIONAL SAFETY INSTRUCTIONS: PNEUMATIC POWER TOOL
1) Air under pressure can cause severe injury.
2) Always shut off air supply, drain hose of air pressure and disconnect the tool from air supply when
not in use before changing accessories or when making repairs.
3) Never direct air at yourself or anyone else.
4) Whipping hoses can cause severe injury. Always check for damaged or loose hoses and fittings.
5) Cold air shall be directed away from hands.
6) Do not use quick disconnect couplings at tool inlet and air-hydraulic impulse wrenches. Use hard-
ened steel (or material with comparable shock resistance) threaded hose fittings.
7) Whenever universal twist couplings (claw couplings) are used, lock pins shall be installed and
whipcheck safety cables should be used to safeguard against possible hose-to-tool and hose-to-
hose connection failure.
8) Do not exceed the maximum air pressure stated on the tool.
9) Never carry an air tool by the hose.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 18
Advertisement
Table of Contents
