Maytag W10560158B-SP Use And Care Manual page 11

NON=USE AND VACATION CARE
Operate your washer only when you are home.
if moving, or not using your washer for a period of time, follow
these steps:
1. Unplug or disconnect power to washer.
2. Turn off water supply to washer, to avoid flooding due
to water pressure surge.
CLEANING YOUR DISPENSER TRAY
You may find laundry product residue leftover in your dispenser
trays. To remove residue, follow this recommended cleaning
procedure:
1. Pull tray out until you feel resistance.
2o Lift up slightly, and then continue pulling out.
3. Wash in warm, soapy water, using a mild detergent.
4. Rinse with warm water.
5. Air dry, or dry with a towel, then place back into slot.
iMPORTANT: Dispenser trays are not dishwasher safe.
W'tNTER STORAGE CARE
m M PORTANT:
To avoid damage, install and store washer
where it will not freeze. Because some water may stay in
hoses, freezing can damage washer, if storing or moving
during freezing weather, winterize your washer.
To winteriTe washer:
1. Shut off both water faucets; disconnect and drain water
inlet hoses.
2. Put 1 qt. (1 L) of R.V.=type antifreeze in basket and run
washer on RINSE & SPiN cycle for about 30 seconds
to mix antifreeze and remaining water.
3. Unplug washer or disconnect power.
f TRANSPORTING YOUR WASHER "
1. Shut off both water faucets. Disconnect and drain water
inlet hoses.
2. if washer will be moved during freezing weather, follow
WINTER STORAG E CARE directions before moving.
3. Disconnect drain hose from drain system and drain any
remaining water into a pan or bucket. Disconnect drain
hose from back of washer.
4. Unplug power cord.
5. Place inlet hoses and drain hose inside washer basket.
6. Drape power cord over edge and into washer basket.
7. Place packing tray from original shipping materials back
inside washer. If you do not have packing tray, place heavy
blankets or towels into basket opening. Close lid and place
tape over lid and down front of washer. Keep lid taped until
washer is placed in new location.
f REtNSTALLING/U$|NG WASHER AGAIN *
To reinstall washer after non=use, vacation, winter storage,
or moving:
1. Refer to "Installation Instructions" to locate, level, and
connect washer.
2. Before using again, run washer through the following
recommended procedure:
To use washer again:
1. Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets.
ElectricaU Shock Hazard
Plug (nto a grounded 3 prong out(et.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to fommowthese instructions can result in death,
fire, or emectricaU shock.
2o Plug in washer or reconnect power.
3, Run washer through BULKY/SHEETS cycle to clean
washer and remove antifreeze, if used. Use only HE
High Efficiency detergent. Use 1/2 the manufacturer's
recommended amount for a medium=size load.
11