Hazard Warning Lights; Changing A Wheel - Fiat 500L Owner's Handbook Manual

HAZARD WARNING
LIGHTS
CONTROL
Press button fig. 104 to switch the
lights on/off. When the hazard warning
lights are on, the and warning
lights flash.
104
Emergency braking
In the event of emergency braking the
hazard warning lights switch on
automatically as well as warning lights
and in the instrument panel.
The lights switch off automatically when
emergency braking ceases.

CHANGING A WHEEL

118) 119) 120) 121) 122)
JACK
Please note that:
❒ the jack weight is 1,76 kg;
❒ the jack requires no adjustment;
❒ the jack cannot be repaired and in
the event of a fault it must be replaced
by another original one;
❒ no tool other than its cranking device
may be fitted on the jack.
WHEEL REPLACEMENT
PROCEDURE
Proceed as follows:
F0Y0037C
❒ stop the vehicle in a position that is
not dangerous for oncoming traffic
where you can change the wheel safely.
The ground should be flat if possible,
and sufficiently firm;
❒ switch off the engine, pull up the
handbrake and engage the 1
reverse. Wear the reflective safety
jacket (compulsory by law) before
getting out of the vehicle;
❒ 500L versions: open the tailgate and
lift the carpet;
❒ 500L LIVING versions: open the
tailgate, lift the load platform of
the "Cargo Magic Space" holding it with
one hand and then take the toolbox.
63)
❒ 500L versions: using the wrench
A fig. 105 located in the tool box,
loosen the locking device, take the tool
box B and place it close to the wheel
to be replaced. Then take the
space-saver wheel C;
❒ 500L LIVING versions: lift the flap A
fig. 106 located on the luggage
compartment mat, take spanner B from
the tool bag and fit it on device C.
Rotate spanner B anticlockwise in order
to undo the space-saver wheel support
locking bolt, allowing the latter to be
lowered, and use the spanner to take
the wheel out of the vehicle;
❒ 500L LIVING versions: rotate the
device D fig. 107 and release the
space-saver wheel from the mounting
E;
st
gear or
105
F0Y0096C
109