Commissioning Of A Controller With Ethernet Connector On The Dulconnex Gateway - ProMinent DULCOnneX Installation And Operating Instructions Manual

Commissioning of a controller with Ethernet connector on the DULCOnneX
6 Commissioning of a controller with Ethernet connector on
the DULCOnneX gateway
The following is needed:
"DULCOnneX gateway"
n
DULCOnneX access code
n
Controller with Ethernet connector
n
M12 Ethernet cable
n
Wi-Fi connection
n
Smartphone, tablet or PC
n
Connection
1. Use the Ethernet cable to connect the
controller to the "DULCOnneX
gateway".
2. Prepare the socket for the controller
and/or the plug-in power pack but do not
yet insert the plug! This needs to
happen later in a controlled manner.
Setting up the controller
1. Connect the controller to the mains
voltage.
2. In the controller menu, in a menu, such
as Set-up - Bus configuration, make
sure that 192.168.001.201 is entered
as the IP address.
(i.e. DHCP must be deactivated.)
Setting up the "DULCOnneX gateway"
1. Connect the "DULCOnneX gateway" to
the mains voltage.
Only Wi-Fi and not LAN can be used
for the configuration!
2. Connect your PC, laptop or smart
device to the "DULCOnneX" Wi-Fi:
SSID: DULCOnneXgw$$$$ *
Password: FD1960de01
* $$$$ = the last 4 digits of the device's
serial number
3. Use a current web browser to connect
your PC, laptop, smart device, to the
192.168.42.101 .
address
DULCOnneX Settings
WiFi Server Information
Host:
services.prominent.de
Upload-Cycle:
15
Fig. 5
4. On this page you can extend the length
of pauses between the transfer of your
data packages to take the strain off your
network installation or save money.
gateway
seconds
Save Server Settings
P PM 0042 SW
11