Advertisement
INSTALLATION INSTRUCTIONS
Secure the Tailpiece into the P-trap
Wrench tighten the P-trap compression fitting to one quarter turn past hand-tight.
‰
If using soldered connections, solder the joint at the P-trap.
‰
Secure the drain Trim
Open the flip drain and insert the grips of a rubber coated pliers into the drain trim and turn to tighten. Be
‰
careful not to scratch the finish.
Install the Overflow Hood
Secure the backplate to the tub by tightening the bolt to one quarter turn past hand-tight.
‰
Thread the overflow hood into the bolt.
‰
Complete the Bath Installation
Check all drain connections for leaks and repair as needed.
‰
Install the bath faucet according to the bath faucet manufacturer's installation guide.
‰
Refer to the bath manufacturer's installation guide to complete the finished deck or wall around the bath.
‰
1117993_2_A
Page 7 of 7
INSTALL THe wASTe ANd OveRFLOw (CONT'd)
COmPLeTe THe INSTALLATION
Kallista Bath Flip Drain
Questions? Problems? For additional assistance, please contact Kallista's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
Advertisement
