DeWalt DWE4100 Instruction Manual page 8

i_, WARNING: ALWAYS use safety glasses. Everyday eyeglasses are
NO T safety glasses. Also use face or dust mask if cutting operation is
dusty. ALWAYS WEAR CERTIFIEDSAFETY EQUIPMENT_
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI $12.6 ($3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
i_ WARNING: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemicals
known to the State of California to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you
do thb type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disperse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropriate
for the dust exposure. Direct particles away from face and body.
i_ WARNING: Always wear proper personal hearing protection
that conforms to ANSI $12.6 ($3.19) during use. Under some
conditions and duration of use, noise from this product may
contribute to hearing loss.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ................... volts
Hz ................. hertz
.................. minutes
- -- or DC... direct current
_) ................. Class I Construction
(grounded)
A ...................... amperes
W ..................... watts
,x, or AC .......... alternating
current
or AC/DC... alternating or
direct current
[] ................. Class II Construction no .................... no load
(double insulated) speed
.../min ........... per minute n ...................... rated speed
BPM ............. beats per minute _ ..................... earthing
IPM ............... impacts per minute terminal
RPM ............. revolutions per _, ..................... safety alert
minute symbol
sfpm ............. surface feet per minute
SAVE THESE INSTRUCTIONS FOR
FUTURE USE