DeWalt DWE4100 Instruction Manual page 10

4-1/2" (114.3 mnl
Type 27 guard
backing flange
Type 27 depressed
center wheel
threaded clamp nut
ATTACHING SIDE HANDLE (FIG. 2)
The side handle (C) can be fitted to either side of
the gear case in the threaded holes, as shown.
Before using the tool, check that the handle is
tightened securely. Use a wrench to firmly
tighten the side handle.
Grinding Wheels
Type 27 guard
Type 27 hubbed wheel
FIG. 2
Wire Wheels
Type 27 guard
3" (76.2 mm)
wire cup brush
Type 27 guard
4" (101.6 mm) wire wheel
Rotating the Gear Case
(Fig. 3)
1. Remove the four corner screws
attaching the gear case to motor
housing.
2. Without separating the gear case from
motor housing, rotate the gear case
head to desired position.
NOTE" If the gear case and motor housing become separated
by more than 1/8" (3.17 mm), the tool must be serviced and
re-assembled by a DEWALT service center. Failure to have the tool
serviced may cause brush, motor and bearing failure.
3. Reinstall screws to attach the gear case to the motor housing.
Tighten screws to 18 in.-Ibs, torque. Overtightening could cause
screws to strip.