GE CT9070 Owner's Manual page 19

Troubleshooting tips ... Before you call for service
Possible Cause What To Do
Oven light does not work Light bulb is broken or defective. = Call for service.
Oven will not self-clean
Excessive smoking
during clean cycle
Excessive smoking
during broiling
w
Oven door will not open
after a clean cycle
Oven not clean after a
"DOOR I_1"flashes in the
"DOOR _" light is on
when you want to cook
Pad operating light is broken.
The temperature is too high to set
a self=clean operation.
Oven controls improperly set.
Excessive soil or grease.
Food too close to burner element.
Oven too hot.
Oven controls improperly set.
Oven was heavily soiled.
The self-clean cycle has been
selected but the door is not closed.
"DOOR I_1"will flash while the oven
door is locking to start self-clean
and steam clean.
The oven door is locked because
the temperature inside the oven
has not dropped below the locking
temperature.
"F-- and a number or You have a function error code.
letter" flash in the display
If the function code repeats.
Display goes blank A fuse in your home may be blown
or the circuit breaker tripped.
The clock is turned off or display
sleep is turned on.
Oven is in Sabbath Mode.
Power outage, clock Power outage or surge
flashes
"Burning" or "oily" odor This is normal in a new oven and
emitting from the vent will disappear in time.
Strong odor An odor from the insulation
around the inside of the oven is
normal for the first few times the
oven is used.
A cooling fan may automatically
turn on.
My oven door glass No. The inner oven glass is coated
appears to be "tinted" or with a heat barrier to reflect the
have a "rainbow" color. Is heat back into the oven to prevent
this defective? heat loss and keep the outer door
cool while baking.
Call for service.
Allow the oven to cool and reset the controls.
See the Cleaning the Oven section.
Turn both knobs to OFF. Open the windows to rid the
room of smoke. Wait until the LOCKED light goes off.
Wipe up the excess soil and reset the clean cycle.
Lower the rack position of the food.
Allow the oven to cool below locking temperature.
See the Cleaning the Oven section.
Clean up heavy spiltovers before starting the clean cycle.
Heavily soiled ovens may need to self-clean again or for a
longer period of time.
Close the oven door. Wait for oven door to finish locking.
This is normal.
Allow the oven to cool.
Press the mini knob. Allow the oven to cool for one hour.
Put the oven back into operation.
Disconnect all power to the oven for at least 30 seconds
and then reconnect power, if the function error code
repeats, call for service.
Replace the fuse or reset the circuit breaker.
See the Special Features section.
Verify that the oven is not in Sabbath Mode.
See the Special Features section.
Reset the clock. If the oven was in use, you must reset it
by pressing the mini knob, setting the clock and resetting
any cooking function.
To speed the process, set a self-clean cycle for a minimum
of 3 hours. See the Cleaning the Oven section.
This is temporary and will go away after several uses or a
self-clean cycle.
This is normal. The cooling fan will turn on to cool internal
parts. It may run for up to 1-1/2 hours after the oven is
turned off.
This is normal. Under certain light or angles, you may see
this tint or rainbow color.
-N
O
C
FI3
I
O
O
-N
m
Z
©
-N
m