Advertisement
Available languages
Available languages
TOOLS REQUIRED:
3/8" wrench
Ftat-tip Screwdriver
Hardware Included:
1/4-20 Hex Nut (Qty: 16)
1/4-20 x A38-in HW Screw (Qty: 16)
@
CASTER INSTALLATION
Items Needed:
1/4 = 20 x A38" (Qty: 16)
1/4 = 20 Nut (Qty: 16)
Screwdriver
3/8=in Wrench
Process:
- Remove bottom drawers. (See Operation Section, Part
B.)
- Lay the cabinet on its back. Use packaging materiat to
protect the finish.
o Mount both swivel casters on the same side of the unit as
the side handle.
-Attach the casters using (4) 1/4 - 20 x 518" screws and (4)
1/4 - 20 nuts per caster.
o Wrench tighten all screws, it is recommended
not to
exceed 80 inch pounds of torque.
o Return the unit to its upright position.
- Reinstall bottom drawers. (See Operation Section, Part
C.)
Chest:
Literature
Hardware bag
Caster pack
Caster pack
Nut
......
\
\
\
Screw
NOTE: Not all operation instructions witt relate to your
model.
O
THE LOCKBAR FOR THE ROLL-AWAY iS STORED iN A
SLOT iN THE TOP FRONT CORNER OF THE UNIT.
TO LOCK ROLL-AWAY
Process:
o insert the straight end of the tockbar into the slot in the
base.
o Move the tockbar toward the unit until the bent end fits
into the slot near the lock.
o Lock with the key.
TO UNLOCK ROLL-AWAY
CABINET
o Reverse above procedure.
NOTE: If your unit is equipped with a storage compartment
with a panel at the bottom, pull panel out, lift up and push
panel back into unit to gain access to compartment.
Advertisement
