Peavey Transtube Series Operating Manual page 13

Stereo operation with external effcts-
Stereo operation with two Transformer 212 units-
All manuals and user guides at all-guides.com
Transformer 212
Recommended Hookups
Connecting to outboard processors
NOTE: Use four mono, shielded patch cables to connect to the outboard processor. Use the
PFC 4 cable (provided) to connect the PFC 4 foot controller.
NOTE: The top unit is considered the master unit in this diagram. The bottom unit is the slave unit. Adjust
the Master Volume of the top unit to control the level of both units. Use two shielded mono "Y" cables to
connect the two units. Use the PFC 4 cable (provided) to connect the PFC 4 foot controller.
Linking two Transformer 212s
NOTE: A standard patch cable may be used here instead of the
"Y" cable shown. Simply patch to the front input of the unit for some
interesting effects doubling. Be sure to balance the Master Volume controls of
the two units (if desired), since both come into play using this configuration.
13
Out In Out In
Two mono "Y"
shielded cables