2. The gym equipment does not seem to work with your chest
•
3. Interference from another person's heart rate monitor - their
•
•
4. The signal is jammed - the heart rate reading on your watch is
•
WARNING
electromagnetic disturbances. These may occur near high voltage
power lines, traffic lights, overhead lines of electric railways, electric
bus lines or trams, televisions, car motors, bike computers, some
motor driven exercise equipment, cellular phones or when you
walk through electric security gates.
SE211 English R3 OP
All manuals and user guides at all-guides.com
belt and the digital icon
Most gym equipment is compatible with the analog system .
Press and hold the chest belt button for 4 seconds to change
from digital to analog. Then force a signal search (see "Signal
Search" section).
heart rate readings appear on your watch, or the heart rate
monitor shows "0":
Press the chest belt button to get the watch to receive your
chest belt signal. Do not press and hold the chest belt button,
as it will change the transmission signal from digital to analog.
Take the chest belt off for 12 seconds to automatically change
your User ID. (The watch has 4 User ID's. When the watch
receives the chest belt signal it will tell you which User ID it
has selected. Only products with a digital coding system have
User ID capability.)
flashing:
There is too much interference in the environment for your
heart rate monitor to function. Move to an area where the heart
rate reading stops flashing.
Signal interference in the environment can be due to
13
Black
is displayed:
13
8/28/04, 3:49 PM