Setting The Lens -Mode Dip Switch - GE KTC-XP1 User Manual

KTC-XP1 UltraView Camera
2.2 S
ETTING THE
Note: If your lens has a manual iris, ignore this switch. It is for autoiris lenses only.
See Figure 3 and set switch as shown:
Set to VD
(video drive) for:
Autoiris lenses
with built-in amplifier
(i.e., video-type
lenses)
Figure 3. Lens-mode DIP switch settings and iris level adjustment
Note: When the lens-mode DIP switch is set to DD, you can use the DD level screw (iris
level adjustment) to ensure the correct exposure of images for the camera's position and
the lighting conditions. Use an insulated tool to rotate the screw. Observe the results on the
monitor screen for the best setting.
Note: The circuitry and programming must be set to the same setting for autoiris lenses.
Refer to section 3.2.2.3 Setting the Lens Mode and Adjusting the Defaults.
Installation continues on next page.
1047441A / February 2004
L -M DIP S
ENS ODE WITCH
Set to DD
(direct drive) for:
Autoiris lenses
without amplifier
(i.e., DC-type
lenses)
DD adjustment
(see note)
Installation
7