Stihl FS 40 Instruction Manual page 9

Use only a spark plug of the type
approved by STIHL and make sure it is
in good condition – see "Specifications".
Inspect the ignition lead (insulation in
good condition, secure connection).
Check the condition of the muffler.
To reduce the risk of fire and damage
to hearing, do not operate your
machine if the muffler is damaged or
missing.
Do not touch a hot muffler since burn
injury will result.
Maintenance, replacement, or repair
of the emission control devices and
systems may be performed by any
nonroad engine repair establishment
or individual. However, if you make a
warranty claim for a component
which has not been serviced or
maintained properly or if
nonapproved replacement parts were
used, STIHL may deny coverage.
For any maintenance please refer to the
maintenance chart and to the warranty
statement near the end of the instruction
manual.
FS 40, FS 40 C, FS 50, FS 50 C
Symbols on Deflectors
An arrow on the deflector (inside and
outside) shows the correct direction of
rotation of the cutting attachments.
Mowing Head with Nylon Lines
Nylon line achieves a soft cut for edging
and trimming around fence posts, trees,
etc. – less risk of damaging tree bark.
To reduce the risk of injury,
never use steel wire in place of
the nylon cutting line.
STIHL FixCut
Check the wear limit marks!
N If the raised moldings (1) on the
base of the attachment are worn as
shown in the illustration (above
right), do not continue using the
mowing head. Install a new one.
There is otherwise a risk of injury
from thrown parts of the head.
English
7