Appendices; Specifications - Tascam FW-1884 Owner's Manual

7.1

Specifications

Analog I/O
Mic input 1-8 (Balanced)
Connector: 3-pin XLR jack x 8 (1: GND, 2: Hot, 3: Cold)
Input imped- : 2.2k ohm
ance
Adjustable : –56dBu (TRIM max) to –2 dBu (TRIM min)
Input range
Maximum gain : +54 dB
Line input 1-8 (Balanced)
Connector: 1/4 inch TRS jack x 8
Input imped- : 10k ohm at LINE/MIC
ance
1M ohm at GUITAR (LINE Input: 8 Switchable)
Adjustable : –42 dBu (TRIM max) to +12 dBu (TRIM min.)
input range
Maximum gain : +54 dB
Insert 1-8 (Unbalanced)
Connector: 1/4 inch TRS jack with tip SW x 8 (T=SEND,
R=RETURN, S=GND)
Send
Impedance : 100 ohm
Normal level : -2 dBu
Maximum level : +14 dBu
Return
Impedance: 10k ohm
Normal level : -2 dBu
Headroom : 16 dB
Line/Mic or Guitar select SW
Line/Mic 10k ohm / 2.2k ohm
Guitar 1M ohm
7 – Appendices
Stereo / Surround monitor output (Balanced)
(Analog output terminal for Master / Monitor. In DAW Controller
mode, Stereo / Surround Mode can be switched over from control
panel on PC. Stereo L-R and Surround1-2 are used commonly.)
Connector: 1/4 inch TRS jack x 8
Output imped- 100 ohm
ance:
Nominal out- : +4 dBu
put level
Maximum out- : +20 dBu
put level
Phones output (Stereo)
Connector: 1/4 inch TRS jack (T = L, R = R, S = GND) x 1
Max output 52 mW + 52 mW (32 ohm)
power:
Digital I/O
Digital input (Coaxial)
2ch serial digital audio signal input terminal. ADAT/Optical Input
terminal is selectable. In the case of Hi sampling, Hi-speed mode is
supported.
Connector: RCA jack x 1
Input imped- 75ohm
ance:
Format: AES3-1992 or IEC60958
Audio bit 24bit
length:
Digital output (Coaxial)
2ch serial digital audio signal output terminal. ADAT/Optical Out-
put is selectable. In the case of Hi sampling, Hi-speed mode is sup-
ported.
Connector: RCA jack x 1
Output imped- : 75ohm
ance
Format: IEC60958 (Selectable)
Audio bit 24bit
length:
TASCAM FW-1884 Owner's Manual
37