Midi Programming Tab - Tascam FW-1884 Owner's Manual

5 – Host Computer Interfacing
5.1.3

MIDI PROGRAMMING TAB

This tab is used to program the FW-1884's control sur-
face in MIDI CTL mode. For detailed information on
using this function, please refer to section 4.2, "MIDI
Control Mode – (General Notes)".
Here's a quick scenario:
ming mode ... firmware sets subcode quadlet to "start
of programming" command, "0xC0000080".
The host software starts up the MIDI Prog tab of the
control panel, with everything blank/grayed-out.
Now press the MUTE2 key while in Bank2 on an ES
unit, and the subcode quadlet is written as
"0x09414CE7".
34
TASCAM FW-1884 Owner's Manual
Enter MIDI program-
The host driver senses the change in the subcode qua-
dlet and the control panel displays its programming
information, something like:
Control: Mute 2
Bank: 2
X Note on/off103 (decimal)
O Controller
O Toggled Controller
Channel: 12
Port 1
O
Now if you click the "up" arrow next to the channel
number, the control panel updates to:
Control: Mute 2
Bank: 2
X Note on/off103
O Controller
O Toggled Controller
Channel: 13
Port 1
O
An asynchronous quadlet write is sent with a value of
"0x09414DE7".
When you exit MIDI programming mode the subcode
quadlet is set to "0xC0010080".
The host software detects the subcode change and
blanks/grays-out the MIDI Prog tab.
234
OxO
234
OxO