Rockwell Shop Series Manual

Rockwell Shop Series Manual

850w rotary hammer
Hide thumbs Also See for Shop Series:

Advertisement

850W ROTARY HAMMER
EN
RS3000K

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Shop Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Rockwell Shop Series

  • Page 1 850W ROTARY HAMMER RS3000K...
  • Page 3 RS3000K...
  • Page 4 RS3000K...
  • Page 5: Component List

    ROTARY HAMMER COMPONENT LIST FASTENINg SLEEvE DIAL SELECTOR gEAR bOx COvER ON/OFF SWITCH LEvER SELECTOR MAINS POWER CAbLE CAP OF CARbON bRuSH AuxILIARY HANDLE DuST COvER SDS DRILL bITS x 3 (8, 10, 12x150MM) gEAR bOx COvER SPANNER x 1 SDS CHISEL bIT x 2, 250MM (1 FLAT CHISEL, 1 POINT CHISEL) DEPTH gAugE x 1 gREASE TubE x 1...
  • Page 6: Electrical Safety

    ROTARY HAMMER liquids, gases or dust. Power tools create sparks which at all times Proper footing and balance enables better may ignite the dust or fumes. control of the tool in unexpected situations. c) Keep bystanders, children, and visitors away while f) Dress properly.
  • Page 7: General Description

    ROTARY HAMMER This will ensure that the safety of the power tool is at all times especially when using the chisel actions. maintained. Proper safety gloves are also recommended. When using in chisel mode a dust mask is necessary because of the cement dust created by the action.
  • Page 8: Technical Data

    ROTARY HAMMER SYMbOLS TECHNICAL DATA Rated voltage 230-240V~50 Hz Read the manual Rated power 850 W No load speed 800/min Rated impact Energy 3.5 J Warning Impact rate 3200min Chuck type SDS-plus Steel Ø13mm Double insulation Masonry Ø26mm Wood Ø32mm Sound pressure level 96.2dB(A) Wear ear protection...
  • Page 9: Drilling Function

    ROTARY HAMMER 4. OPERATINg THE SAFETY ON/OFF SWITCH YOU DO SO. To operate the tool simply depress the switch to turn on After deciding if hammer or normal drilling is required and release to stop. (See C) proceed as follows: WARNINg!If the hammer/drill selector will not go Before installing drill bit, remove mains plug from mains into position, turn the gear box.
  • Page 10: Maintenance

    ROTARY HAMMER MAINTENANCE Your power tool requires no additional lubrication or maintenance. There are no user serviceable parts in your power tool. Never use water or chemical cleaners to clean your power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep the motor ventilation slots clean.
  • Page 12 MADE IN PRC...

This manual is also suitable for:

Shop rs3000k

Table of Contents