Connect Power To A Pa-800 Series Firewall - Palo Alto PA-800 Series Hardware Reference Manual

Connect Power to a PA-800 Series Firewall

To avoid injury to yourself or damage to your Palo Alto Networks
resides on the hardware, read the
Remove the nut and star washer from the ground stud.
STEP 1 |
STEP 2 | Crimp a 14AWG ground cable to a ring lug (cable and lug not included) and then attach the ring
lug to the ground stud on the firewall. Replace the star washers and nuts and torque to 25 in-
lbs. Connect the other end of the cable to earth ground.
STEP 3 | Connect the AC power cord to the power input on the back of the firewall. On a PA-850
firewall, connect a second power cord to the second power input.
STEP 4 |
(PA-850 firewall only)
Connect the other end of the power cord to an AC power source. After power is connected,
STEP 5 |
the firewall powers on as indicated by the PWR LED on the front of the firewall.
STEP 6 |
(PA-850 firewall only)
second power supply also turns green.
Connect the second power cord through a different circuit breaker to provide power
redundancy and to allow for electrical circuit maintenance.
PA-800 SERIES NEXT-GEN FIREWALL HARDWARE REFERENCE | Connect Power to a PA-800 Series Firewall
Product Safety
Secure the power cords to the power supplies using the Velcro straps.
Connect the second power cord to an AC power source; the LED for the
®
hardware or the data that
Warnings.
27
Overview
2019 Palo Alto Networks, Inc.
©