Table of Contents
Advertisement
4
Press
to view the hardware informa-
MODE
tion (the maximum speed available and the
model hardware serial number):
H /W
IN FO
1 110 80 00 00 000 00 0
5
Press
once more to view the number
MODE
of discs successfully copied (
The Session Mode option
The
SESSION MODE
left as
.
CLOSE
Cascading
When two units are cascaded, the master unit can use
up to four slave drives of the slave unit.
1
With the two power switches on each unit
turned OFF, use the supplied cascade cable
to link the two units.
2
Set the switch on the rear of one unit to
, and on the other to
MASTER
that if you set both to
, neither unit will work properly.
SLAVE
3
Turn on the rear power switches and then
turn on the front power switches (always
turning on the slave first).
x1 6
) and the
OK
option should always be
. Note
SLAVE
MASTER
or both to
7 – Other functions
number of discs for which copying has been
attempted (
TOTAL
on which track extraction has been per-
formed are not included in these totals.
O K
T OTA L
There is one exception to this: if you are adding data
to audio discs using a computer to make CD-EXTRA
discs. Consult the reference manual of your computer
CD-R software for details.
The slave unit shows
display.
The slave front panel controls and display are dis-
abled, except for the drive eject keys, headphone
jacks and volume controls (which can be used at the
appropriate points in the different procedures).
When the cascade master is cycling through the slave
drives, it uses eight drives instead of four (slave drive
1 on the slave unit becomes drive 5, etc.).
All other operations are carried out as usual.
NOTE
If you turn off the SLAVE unit when two units are con-
nected in cascade mode, the MASTER unit cannot be
used.
TASCAM CD-D1x4
) so far. Note that discs
1 32 1
1 33 4
on the
Slave Mode
19
Advertisement
Table of Contents
