Copying The Disc - Tascam CD-D1X4 Owner's Manual

5 – Disc copy

Copying the disc

1 If the display does not show
with the current speed under-
START?
neath, press MODE
key
ENTER
I NS E RT
S OU R CE D I SC
The drive tray opens. Load the
MASTER
master disc and close the tray.
2 The trays of any slave drives which do not
currently contain recordable discs will open.
Place target recordable discs in the slave disc
trays (you don't have to put a disc in every
tray).
If you decide that you do not want to make a
copy at this stage, press the
return to the mode selection menu.
The display alternates
I NS E RT
T AR G ET D I SC
with:
P RE S S EN T ER
T O S TA RT
Note that these two displays above do not
appear if a target disc has already been
loaded in all slave drives.
3
When all the slave disc trays are filled and
closed, wait until the discs are recognized by
the drives (the indicators go out), the copy
operation starts if all trays are filled. Note
that if you are copying fewer than four discs
at this time, you should press
you have loaded the slave drive with the last
14
TASCAM CD-D1x4
COPY
until it does. Press the
key to
ESCAPE
when
ENTER
disc you will use to copy onto. The display
then shows.
A NA LYZ IN G
as the CD-D1x4 analyzes the source disc.
4
The copying process proceeds, and the screen
shows:
C OP Y
C D- DA » »"" "
As copying progresses, the "bargraph" fills
as the percentage does up. The time shown is
the total time to be copied.
NOTE
S
Once a copy operation has started, although it can be
stopped before the copy operation is complete, this will
make the CD-R disc useless for any purpose.
Do not use warped discs or discs with off-center holes
with the CD-D1x4.
While the copy operation is in progress, make sure that
the CD-D1x4 is not subjected to vibration or mechanical
shocks.
You may press and hold the
onds or more to abort the copying process. However,
note that this will make the target discs unusable for
further operations.
You can also press and hold the
seconds or more to abort verification or read check
processes. Aborting these processes will not spoil the
target discs.
If you have selected one of the verification options
together with the copy process (see "Additional copy
modes" on page 12), the name of these processes will
be shown on the display as the process is carried out.
5 The drive trays open automatically when the
copy procedure is finished.
S OU RCE
15 :26
40%
key for 5 sec-
ESCAPE
key for 5
ESCAPE