Simulation - Tascam CD-D1X4 Owner's Manual

The simulation operation is functionally similar to
the copy operation, except that the writing of data to
the slave discs is simulated. This is useful to make
sure that data can be transferred at the selected rate
between the master and slave discs.
1 Press the key until the display shows:
MODE
S IMU LA TI ON ?
2 Press :
ENTER
I NSE RT
S OUR CE D IS C
3
If the source disc is not already loaded, place
the source disc in the
close the tray. The trays of any slave drives
which do not currently contain recordable
discs will open.
I NSE RT
T ARG ET D IS C
with:
P RES S EN TE R
T O S TA RT
These do not appear if a target disc is already
present in all slave drives.
4
Place target recordable discs in the slave disc
trays (you don't have to put a disc in every
tray).
(FA ST )
disc tray and
MASTER
If you decide that you do not want to perform
the simulation at this stage, press the
key to return to the mode selection
ESCAPE
menu.
5
Close the trays, wait for the indicators to go
out, and the operation starts. Note that if you
are simulating a write of fewer than four
discs, you should press
have loaded the slave drive with the last tar-
get disc you will use for the simulation.
The CD-D1x4 starts to read and analyze the
source disc.
A NAL YZI NG
6 The simulation process proceeds, and the
screen shows:
S IMU LAT IO N
C D-D A »» """
As the process continues, the "bargraph" fills
as the percentage does up.
7
Pressing ESCAPE during a simulated copy
halts the test copy process and returns to the
main menu. Since the test process does not
write to disc, the target discs are not affected
in any way.
TASCAM CD-D1x4
6 – Simulation
when you
ENTER
MA ST ER
1 5: 26
4 0%
15