Table of Contents
Advertisement
3 − Playback
IMPORTANT SAFETY PRECAUTIONS
Playback 1 (either TAPE 1 or TAPE 2)
1. Switch on the
POWER
2. Load a pre-recorded tape into the TAPE 1 or 2
deck.
Press the
key (
EJECT
compartment. Insert the cassette tape with its
open edge facing down, the desired side facing
you. Then, close the cassette compartment by
pushing on its front part.
This cassette deck can play back Normal (Type I),
Chrome (Type II) and Metal (Type IV) tapes.
For the sake of simplicity, we refer to the tape side
facing you as Side "A" and to the tape side facing
away as Side "B". When you insert a cassette with
Sides "A" and "B" reversed, Side "A" should read
Side "B" and Side "B" should read Side "A".
3. Select a reverse mode setting using the
MODE
switch.
1
TASCAM 202
IV
MK
.
) to open the cassette
ø
Side "A" facing you
REV
You have a choice of three settings:
: One way mode
Ä
Set the switch to this position to playback
only one side.
: Two way mode
Ë
Set the switch to this position to play back
both sides of the tape in one session. When
playback reaches the end of side "A", the
playback direction is automatically reversed,
and playback continues on side "B".
: Repeat mode
ä
Set the switch to this position. Both sides
of the tape in the Tape 1 deck is played back
continuously until you stop the operation,
and both sides of the tape in the Tape 2 deck
is played back as many as 5 times.
4. Set the
switch.
DOLBY NR
Set the switch to the
ON
back tapes recorded with Dolby NR.
To play tapes recorded without Dolby NR, set the
switch to the
position.
OFF
5. Press the
PLAY
key (
˙
Pressing the
key starts playback from side
¥
"A".
Playback stops when reaching the end of side "A"
if the reverse mode is set to
mode is set to
, playback continues on side
Ë
"B", stopping at the end of side "B". If the reverse
mode is set to
, playback cycles through both
ä
tape sides 5 times.
Pressing the
key starts playback from side
˙
"B".
Playback stops when reaching the end of side "B"
if the reverse mode is set to either
the reverse mode is set to
back, and then playback cycles through both tape
sides 4 times.
position when playing
or
).
¥
. If the reverse
Ä
or
. If
Ä
Ë
, side "B" is played
ä
Advertisement
Table of Contents
