Adjusting Mix Recording Level; Continuous Recording - Tascam D00935220B Owner's Manual

4 − Recording IMPORTANT SAFETY PRECAUTIONS

Adjusting mix recording level

To record a mix of voice and another audio source,
you need to adjust the mic input level and then fine
tune the overall recording level.
1. Plug your microphone into the
front panel.
2. Start playing the audio source, switch the deck
into the record-pause mode (by pressing the
key), and temporarily adjust the
RECORD
control to a relatively low level.
LEVEL
3. Speak into the mic and adjust the
control to get the optimum balance between
your voice and the other source.
4. Fine tune the overall recording level using
the REC LEVEL control so that the level meter
reads 0 dB at peaks.
5. When everything is ready, start recording as
instructed earlier in this manual.

Continuous recording

This function allows you to make uninterrupted
recordings on both sides of two tapes.
1. Load cassette tapes for recording into the
TAPE 1 and TAPE 2 compartments.
0
TASCAM 202 IV
MK
jack on the
MIC
REC
MIC level
Side "A" facing you
Audio source
Adjustment of
mic input level
2. Set the switch to the
REV MODE
) position.
REC/PLAY
Set the switch to the
DOLBY NR
you want to.
3. Press the TAPE 1 deck's
The deck enters the record-pause mode.
will light on the display. Now adjust the
recording level and any other settings, as re-
quired.
Adjustment of overall
recording level
(
CONT
ä
position if
ON
key.
RECORD
and
π