Table of Contents
Advertisement
IMPORTANT SAFETY PRECAUTIONS
3 − Playback
Continuous playback
Continuous playback can be performed between
TAPE 1 and TAPE 2. When one tape is played back to
the end, the other tape automatically starts playback,
in a relay fashion.
1. Load pre-recorded tapes into the TAPE 1 and
TAPE 2 compartments.
2. Set the
switch.
DOLBY NR
Always set the
DOLBY NR
position that was used for recording.
3. Set the
switch to the
REV MODE
) position.
PLAY
Blank scan
The Blank Scan function detects 10 seconds or more
of blank and skips over it.
To activate this function, press the
followed by the desired play key (
The
BLANK SCAN
indicator lights when this function is
activated.
1
TASCAM 202
IV
MK
3
switch to the same
(
CONT
ä
key
BLANK SCAN
or
).
˙
¥
4. Press the
PLAY
key (
˙
want to start first.
You can start continuous playback from either
TAPE 1 or TAPE 2.
Playback cycles through four tape sides as fol-
lows, and will continue until you stop the opera-
tion.
TAPE 1
Side"A"
™
TAPE 2
Side "B"
To disable this function, press the
again. The indicator turns off.
Very quiet passages in music are likely to be identified
as blanks. If you are worried about this, switch off
Blank Scan.
or
) of the deck you
¥
Side "B"
∑
≈
Side "A"
ß
key
BLANK SCAN
Advertisement
Table of Contents
