Playback; Using Just One Of The Two Available Decks; Continuous Play On Both Decks - Tascam 302mkII Owner's Manual

You can press
PAUSE
Play Pause mode and deck 2 into Record Pause
mode.

Playback

Using Just One of the Two Available Decks

1. Connect the amp/speaker system to the OUTPUT
connectors of the deck you intend to use.
2. Insert the tape into either deck 1 or 2.
3. Make the following switch settings :
switch to Ä to play only one tape
" REV MODE
side or ä to play both sides continuously.

Continuous Play on Both Decks

You can either connect a single amp/speaker system to
the deck 1's output or an additional amp/speaker
system can be connected to the deck 2's output as well.
To have both decks play sequentially :
1. Set the
INPUT/OUTPUT
both decks' outputs are in use or COMMON if only
deck l's output is in use.
2. Set the switch to CONT.
REV MODE
3. Insert the tapes into both decks.
on deck 2 to put deck 1 into
switch to SEPARATE if
Using a Single Unit
9. To stop dubbing in NORM mode and exit this
mode, press STOP on deck 2. In HIGH SPEED
mode, you can press
STOP
" DOLBY NR
switch depending on the tape in use.
If REV MODE is set to Ä and you intend to play
only the reverse tape side, press the Ó button to
have the associated LED start blinking.
4. To start play, press
PLAY
4. Set the
DOLBY NR
depending on the tapes in use.
5. To start sequential play, press
When deck 1 plays up to the end of the reverse side,
deck 2 automatically starts. When deck 1 plays up to
the end of the reverse side, deck 2 automatically starts
playing. When deck 2 plays up to the end af the reverse
side, deck 1 again starts playing. This process
continues until you press
on either deck.
whose LED is blinking.
switch on both decks
on deck 1.
PLAY
on either deck.
STOP
11
TASCAM 302MKII