Table of Contents
Advertisement
4. How to play iPod using one key control system
i). Press the knob to enter the first-level sub-page (control panel).
ii). Choose iPod Control Menu , you can press knob to enter second-level sub-page (see the picture on
"
Page 4).
iii). Rotate the knob to the desired function mode, then press the knob again to enter to the third-level
sub- page. When you choose the (
once( to the left is scroll up, to the right is scroll down). Secondly, press the (
has the same function as "OK/Menu" key on remote control. For all other iPod functions please refer to
page 6, iPod Control Area.
iv). If you want to choose other functions, please refer to step (2) b. above.
5. How to set ALARM, TIME using one key control system
"
i). Press the knob to enter the first-level sub-page (control panel).
ii). Choose Time and Alarm Control Menu , you can press knob to enter second-level sub-Page (see the
"
picture on Page 4).
iii). Rotate the knob to the desired function mode, then press the knob again to enter to the third-level
sub- page.
a. When you choose the Time function, you can rotate the knob to adjust the hour setting, and then
press the knob again to adjust the minute setting. After adjustment, press knob again, the clock icon
on the LCD will flash momentarily to indicate the time has been set successfully.
b. When you choose Alarm function, the operation is similar to the time setup. After finishing the alarm
setup, press knob and hold for 2 seconds to return the third-level subpage for the on&off setting for the
alarm.
6. How to set the system mute using one key control system
i). Press the knob to enter the first-level sub-page (control panel).
ii). Choose
"Mute
Control Menu , you can press knob to enter second-level sub-page (see
the picture on Page 4).
iii). Then press the knob again to set the system mute, it will turn off the
hold for 2 seconds to cancel the mute set
Installing battery in the remote control
Since the remote control will be used for operations, you should begin by installing the supplied battery:
1. Turn the remote control over and pull out the battery compartment cover.
2. Insert the battery according to the polarity markings inside of the battery compart-ment.
3. Close the battery compartment cover.
Notes about the remote control
1. If you find that the remote control can not be used at a normal distance from the main unit, the battery
may be weak and need to be replaced.
2. Remove the battery if the remote control is not used for an extended period of time.
3. If battery is leaking, remove and dispose of it immediately. Avoid touching the leaked material and
splashing it on to clothing, etc. Clean the battery compartment thoroughly before installing new battery.
Trouble Shooting
Problem
Unit will not turn on.
Display can't be turned on.
No sound at all.
Neither of the main channels have
sound.
Unit is operating abnormally
"
) function, it has 2 functions: firstly, rotate knob left or right
"
"
"
"
"
"
"
.
·
The plug is not inserted properly; the socket
has no power.
"
·
·
Incorrect selection of input signal.
The leads are not connected correctly.
·
Mute function is enabled.
·
Sound source is not powered up.
·
The speaker line is not connected properly.
·
·
The signal plug is incorrectly connected or
leads are short-circuited.
·
Interference from strong exterior disturbance,
turn off and then turn on again.
Avoid direct sunlight/heat.
·
Possible Reasons/Solutions
POWER button has not been pressed.
"
.8.
) function once, it
unit's sound. ress knob and
P
Advertisement
Table of Contents
