Black & Decker Surge Xpress F855 Use And Care Book Manual page 11

Need Help?
IRON WON'T
HEAT?
IRON WON'T
START STEAMING?
WATER DROPLETS
COMING FROM
STEAM VENTS?
8. Press and hold the Control
9. Release the Control and tip the
10. Place the iron on its heel rest
1. Is the Power light on? (Press the ON/OFF
Button).
2. If the Light is not on, will a lamp plugged into
the outlet turn on?
3. Is the Heat/Fabric Dial adjusted to a fabric
setting?
1. Check to be sure there is enough water in
the Tank.
2. Is the Adjustable Steam Dial set at
(light),
Adjust the Dial to Dry and back to the
desired steam level.
1. Is the Heat/Fabric Dial set in a steam area
and is the Adjustable Steam Dial set at the
corresponding
(heavy) steam setting?
2. If water droplets continue, reduce the steam
or increase the temperature setting slightly.
11
down until all the water has
been emptied. If necessary,
rock the iron from side to side
and front to back.
iron sideways to allow any
remaining water to drain.
and plug into a standard
electrical outlet. Heat for about
2 minutes to dry out any
remaining water.
(medium), or
(light),
(heavy)?
(medium), or