Table of Contents
Advertisement
• When multiple units and other devices are connected
PoE power
sourcing
equipment
Computer
1) Straight cable
Supplying Power via an AC Adapter
• When only the unit and a computer are connected
Computer
BC-DWX1
AC adapter
(not supplied)
1) Crossover cable
• When multiple units and other devices are connected
BC-DWX1
AC adapter
(not supplied)
Computer
1) Straight cable
2) to AC power supply
BC-DWX1
Hub
PoE power sourcing
equipment
BC-DWX1
to AC power supply
AC adapter
(not supplied)
Hub
Charging
Check that there are no foreign objects or particles in the
charging port, and insert the DWT-B03R or NP-BX1. The
CHARGE indicator of the charging port in which the
DWT-B03R or NP-BX1 was inserted lights, and charging
starts.
You can charge using either of the charging ports.
Notes
If the CHARGE indicator does not light, check that the
device is fully inserted. The device may not charge if it is
not inserted properly.
Inserting the DWT-B03R
You can charge the NP-BX1 while it is inserted in the
DWT-B03R.
Check the orientation of the DWT-B03R, and insert it fully
into the charging port.
For details on inserting the NP-BX1, refer to the operating
instructions for the DWT-B03R.
Inserting the NP-BX1
Insert while making sure that the f mark on the NP-BX1
is at the top and facing the direction of the U mark on the
unit.
Notes
If you insert the DWT-B03R while it is turned on, the
DWT-B03R will turn off, but charging will still occur. The
DWT-B03R will remain turned off, even after you remove
it from the unit.
Checking the charge status
You can check the charge status of battery packs via the
charge/discharge status indicators and CHARGE
indicators.
a: Off
z: Lit
Charge/discharge
status indicators
Immediately after
insertion to 30%
30% to 60%
60% to 90%
6
CHARGE indicator
aaa
z
aaz
z
azz
z
Advertisement
Table of Contents
