Accessories; Manual Breast Pump Converter; Assembling The Manual Breast Pump; Operating The Manual Breast Pump - Philips AVENT SCF334 Manual

English
20

Accessories

Manual breast pump converter

With the manual breast pump converter, you can assemble the manual breast pump.
Before you use the manual breast pump, read the instructions for the electric breast pump
(see chapter ‚Preparing for use', section ‚Using the breast pump'). All instructions for the
electric breast pump also apply to the manual breast pump converter, except the chapters
„Assembling the breast pump" and „Operating the breast pump".

Assembling the manual breast pump

Note: Make sure you have cleaned and sanitized the appropriate parts of the breast pump.
1 Wash your hands thoroughly before you handle the cleaned parts.
Warning: Be careful, the cleaned parts may still be hot. Only start assembling
the breast pump when cleaned parts have cooled down.
Note: You may find it easier to assemble the breast pump while it is wet.
2 Insert the white valve into the pump body from underneath. Push the valve in as far as
possible (Fig. 7).
3 Screw the pump body clockwise onto the bottle until it is securely fixed (Fig. 8).
4 Insert the silicone diaphragm into the pump body from above. Make sure it fits securely
around the rim by pressing down with your fingers to ensure a perfect seal (Fig. 9).
5 Attach the handle onto the diaphragm with stem by hooking the hole in the handle over
the end of the stem. Push down the handle onto the pump body until it clicks into place.
6 Insert the massage cushion into the funnel-shaped section of the pump body (Fig. 10).
7 Push in the inner part of the massage cushion as far as possible and make sure that it is
perfectly sealed all around the rim of the pump body (Fig. 11).
8 Press in between the petals to remove any trapped air (Fig. 12).
Note: Place the cover over the massage cushion to keep the breast pump clean while you
prepare for expressing.
Warning: Always use the breast pump with the massage cushion.

Operating the manual breast pump

1 Wash your hands thoroughly and make sure your breasts are clean.
2 Relax in a comfortable chair (you may wish to use cushions to support your back). Make
sure you have a glass of water nearby.
3 Press the assembled pump body against your breast. Make sure that your nipple is
centered, so that the massage cushion creates an airtight seal (Fig. 16).
4 Make sure that your nipple fits correctly in the cushion (see: Find the best cushion for you).
5 Gently start to press down the handle until you feel the suction on your breast. Then allow
the handle to return to its resting position (Fig. 17).