Installing And Operating Your Freezer - Nordmende RTF247WHA+ User Manual

EN
BEFORE USING THE APPLIANCE
8

Installing and operating your freezer

Before starting to use your freezer, you should pay attention to the
following points:
• Operating voltage for your fridge is 220-240 V at 50Hz.
• We do not take the responsibility of the damages that occur due
to ungrounded usage.
• Place your freezer in a place that it would not be exposed to
direct sunlight.
• Your appliance should be at least 50 cm away from stoves, Gas
ovens and heater cores, and should be at least 5 cm away from
electrical ovens.
• Your freezer should never be used outdoors or left under the rain.
• When your freezer is placed next to a deep freezer, there should
be at least 2 cm between them to prevent humidity on the outer
surface.
• Do not place anything on your freezer, and install your freezer in
a suitable place so that at least 15 cm is available on the upper
side.
• The adjustable front legs should stabilized in an appropriate
height to allow your freezer operate in a stable and proper way.
You can adjust the legs by turning them clockwise (or in the
opposite direction). This should be done before placing food in
the freezer.
• Before using your freezer, wipe all parts with warm water added
with a tea spoonful of sodium bicarbonate, and then rinse with
clean water and dry. Place all parts after cleaning.
• Install the distance adjustment plastic (the part with black vanes
at the rear) by turning it 90° as shown in the figure to prevent the
condenser from touching the wall.
• Freezer should be placed against a wall with a free distance not
exceeding 75 mm.