Advertisement

Instruction Manual
Built in Freezer
Instruction Manual
RITF391A+

Advertisement

Table of Contents
loading

Summary of Contents for Nordmende RITF391A+

  • Page 1 Instruction Manual Built in Freezer Instruction Manual RITF391A+...
  • Page 2 European Safety Certificate Compliance Declaration The manufacturer assumes full responsibility for the compliance of products manufactured with relevant safety, health and environmental protection requirements set out in European Directives. Test reports are available for verification upon request. The manufacturer will present the quality certificate or manufacture license to a refrigerator dealer if so required.
  • Page 3: Table Of Contents

    Content Page Important! 1. Environmental Protection and Proper Disposal..2 It must be noticed that refrigeration system contains 2. Location..............2 refrigerants, which require specialized waste disposal. 3. Installation .............2-3 Contact your local waste disposal center for proper 4. Rating Plate..............3 disposal of an old appliance and contact your local 5.
  • Page 4: Environmental Protection And Proper Disposal

    1.Environmental Protection 3.Installation Proper Disposal a) Remove all package materials. Package materials b) Remove items in the refrigerator. c) Make sure to remove film and tape on the cabinet and The appliance is packaged in a way to prevent damages the door.
  • Page 5: Rating Plate

    Write down the technical data for later reference to avoid Warning! the need for moving the refrigerator when such data are needed. After the refrigerator is positioned, allow it to stand still for at least 2 hours before starting it up to ensure stable Model / Type refrigerant circulation and faultless operation.
  • Page 6: Freezer Compartment

    Turn temperature regulator counterclockwise to the lowest storage, select a medium setting. setting=lightest cooling; 4 Normally, when food requires a long period of storage, (Turn the regulator counterclockwise to the most will select a high setting. power off the refrigerator, compressor will stop) Turn temperature regulator counterclockwise to the NOTE! highest setting=coldest setting;...
  • Page 7: Ice & Ice Cream Making

    Making ice cubes: If a heat exchanger, i.e. condenser, is mounted on the back of refrigerator, dust and lint should be removed regularly to enable efficient heat dissipation and avoid · Add water to ice tray to 3/4 of its volume, place it at the excessive power consumption.
  • Page 8: Problem Diagnosis

    the evaporator surface may get damaged. frequently; Please check: · Wipe off defrost water from time to time with sponge. · The refrigerator/freezer compartment should stand still for at least 2 hours after installation to stabilize the · Place a container of hot water (do not use boiling refrigerant circulation system.
  • Page 9: During A Power Interruption

    handle. 17. Warranty · Defrost and clean the freezer compartment (see “Defrosting”). A thick ice layer will impede refrigeration The terms and conditions as well as the period of warranty performance and increase power consumption. are indicated in the Letter of Warranty enclosed hereto. The dealer will brief you of the same upon purchase.
  • Page 14 Positioning and installing the appliance 1. Once the appliance has been unpacked, check the main voltage is the same as that indicated on the rating plate. 2. If the door opening direction is as required, go to Point 3. Otherwise, reverse the position of the hinges.

Table of Contents