Page 2
IMPORTANT SAFETY INSTRUCTIONS When using this electronic device, basic precautions should always be taken, including the following: 1. Read all instructions before using the product. 2. Do not use this product near water (e.g., near a bathtub, washbowl, kitchen sink, in a wet basement or near a swimming pool etc).
CONTENTS: Before you start Introductions Features Operation Front panel Rear panel Handheld microphone Batteries changing Receiver operation Specifications General specifications...
Introduction Wireless microphone systems with fixed transmitter’s and receiver’s frequency. LiveStar UX3 wireless microphone are combined with handheld transmitter. There are four fixed frequency sets, working on 626.63 MHz, 630.4 MHz, 863.425 MHz and 864.9 MHz Features Fixed transmitter’s and receiver’s frequency ...
Front Panel Power switch Audio frequency indicator LCD display Volume control Radio frequency indicator Rear Panel 1. Antenna connector 3. Unbalanced audio output 2. Main power connector 4. Balanced audio output...
Handheld microphone 1. Microphone capsule 3. Power button 2. Low battery indicator 4. Battery cover and holder Batteries changing Turn battery cover counterclockwise and remove it. Insert 2 units of AA type alkaline batteries. Pay attention to battery polarity. ...
Receiver operation LCD DISPLAY Displays the current settings RF INDICATOR RF indicator became active when the receiver detects a radio signal sent from transmitter. AF INDICATOR This LED indicates detected audio signal. VOLUME CONTROL Allows to adjust audio level in receivers output. POWER BUTTON Press power button to turn on/off the power.
The specifications above are correct at the time of printing this manual. For improvement purposes, all specifications for this unit, including design and appearance, are subject to change without prior notice AMC is a registered trademark of AMC Baltic www.amcpro.eu...