Page 2
IMPORTANT SAFETY INSTRUCTIONS When using this electronic device, basic precautions should always be taken, including the following: 1. Read all instructions before using the product. 2. Do not use this product near water (e.g., near a bathtub, washbowl, kitchen sink, in a wet basement or near a swimming pool etc).
CONTENTS: Before you start Introductions Features Operation Front panel Rear panel Handheld microphone Body pack transmitter Receiver operation Handheld microphone operation Body pack transmitter operation Synchronization Receiver’s menu Specifications General specifications...
Introduction ILive 2x2 - dual wireless receivers with 32 selectable channels and automatic channel targeting. Wireless microphones sets can be combined with handheld or body pack transmitter with variety of microphone selection to use with body pack. Features 2 x 32 selectable channels ...
Receiver operation SYNC BUTTON Press this button to transmit data from receiver to transmitter in order to synchronize microphone or body pack transmitter and receiver. NAVIGATION BUTTONS These buttons are designed to navigate receivers menu and adjust settings. SET BUTTON Short press of this button shows number of current channel for two seconds on LCD screen if channel frequency are displayed for default and otherwise, shows the channel frequency if channel number are set for display default.
Body pack transmitter operation ANTENNA Antennas for RF signal transmitting to the receiver. Covered antenna can reduce working distance, try to keep antenna uncovered in order to guaranty maximum working distance. LCD DISPLAY Displays the current frequency, channel and low battery indication. IR RECEIVER IR receiver allows synchronize body pack and receiver by establishing body pack radio frequency to the same as set in receiver.
Receiver’s menu Long press of SET button brings main menu on the screen, in order to enter the submenu press SET button one more time. Use navigation buttons to navigate menu and adjust settings.
Page 10
F-MODE MENU Activate F-mode menu by pressing SET button for 3 sec. This menu consists from TUNE, CHANNL and EXIT sub menu.
Page 11
TUNE MENU Select tune menu in order to change manually receiver’s frequency in 50 kHz steps. CHANNEL MENU Select CHANNL to set one of the 32 channel’s presets. Before the selecting CHANNL, the default display in the DISPLY menu should be set to CHANNL.
Page 12
DISPLAY MENU Display menu allows to change the default screen view from frequency to channel and otherwise. Select “CHANNL” to display channel number in the screen or select “FREQUE” to display channel frequency in Mhz. SQUELCH MENU The squelch level is adjustable in 5dB steps from 0dB to 20dB. Selecting a smaller value increase the squelch threshold, selecting a higher value reduce the squelch threshold.
Page 13
VOLUME MENU Select VOLUME menu to adjust audio output level. LOCK MENU Lock menu allows lock main panel buttons, except power and SETTING buttons. Please set lock function to off, for unlock. EXIT MENU Select to exit from menu.
General specifications Technical Specifications iLIVE 2x2 receiver Power supply 12-15 V DC, 1.25 A 2 x Balanced XLR , 1 x unbalanced 6,3 mm TS Output JACK Receiver way Two frequency conversion super-heterodynes Intermediate frequency 10,7 MHz Antenna T.H.D < 0,7 % Sensitivity 6 dB μV...
Page 15
Technical Specifications iLIVE 2 body pack transmitter Carrier frequency range 606 MHz – 634,4 MHz Modulation Channels Audio frequency response 45 Hz - 18 kHz S/N ratio > 105 dB Antenna 1/4 wave antenna Input connector 4 pin mini XLR connector Transmitter’s power 3 mW 60 m (Note: actual range depends on RF...
Page 16
AMC is a registered trademark of AMC Baltic www.amcpro.eu...