Hilti TE 6-A22 Original Operating Instructions page 29

5.9 Overhead work
▶ Fit the DCD dust control ring for overhead work.
5.10 Chisel positioning
▶ Set the function selector switch to the
6 Types of work
ATTENTION
Risk of damage by incorrect handling!
▶ Do not operate the switches for direction of rotation and/or function selection during operation.
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Function selector switch
▶ Set the function selector switch to the desired working position.
▶ Do not operate the function selector switch while the motor is running. Risk of damage!
6.2 Forward/reverse
▶ Set the forward/reverse switch to the desired direction of rotation.
6.3 Drilling without hammer action
▶ Set the function selector switch to the
6.4 Drilling with hammer action
▶ Set the function selector switch to the
6.5 Chiseling
▶ Set the function selector switch to the
▶ For optimum motor cooling, select the forward direction, i.e. clockwise (direction of rotation for
drilling).
7 Care and maintenance
7.1 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Care of the Li­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
*2166238*
9
10
position.
10
11
position.
position.
position.
2166238 English 21