Hilti TE 6-A22 Original Operating Instructions page 28

5 Operation
5.1 Preparations at the workplace
CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.2 Inserting the battery
CAUTION
Risk of injury! Inadvertent starting of the rotary hammer drill.
▶ Before installing the battery, check that the rotary hammer drill is switched off and that the forward/reverse
switch is in the middle position (i.e. safety lock engaged).
1. Push the battery into the battery holder until it engages with an audible click.
2. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out toward the rear.
5.4 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the rotary hammer drill.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping band is
engaged in the groove in the tool.
1. Release the side handle clamping band by turning the handle grip.
2. From the front, slide the depth gauge into the 2 guide holes.
3. Tighten the side handle clamping band by turning the handle grip.
5.5 Fitting and adjusting the depth gauge
▶ Fit the depth gauge, if necessary, and adjust it correctly.
5.6 Fitting / removing the chuck
CAUTION
Risk of injury! The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the tool.
▶ Fit / remove the chuck.
5.7 Inserting the tool
1. Lightly grease the connection end of the accessory tool.
▶ Use only genuine Hilti grease. Using the wrong grease can result in damage to the tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
3. After fitting the accessory tool, grip it and pull it in order to check that it is securely engaged.
▶ The product is ready for use.
5.8 Removing the accessory tool
▶ Pull the chuck back as far as it will go and remove the accessory tool.
20 English
2
3
4
5
6
7
8
2166238
*2166238*