Package Contents - TrekStor DataStation pocket pace 3.0 Operating Instructions Manual

m
Never place the device close to a source of heat, and protect it from
direct sunlight.
h
Make sure that the surroundings are as dust-free as possible when
you use and store the device.
g
Never clean the surface of the device with solvents, paint thinners,
cleansers or other chemical products. Instead, use a soft, dry cloth or
a soft brush.
p In certain circumstances, exposing the device to an electrostatic
discharge may interrupt the data transfer between the device and
the computer and impair the functions of the device. If this occurs,
the device should be unplugged from the USB port and then plugged
in again.
o
Do not use USB cables longer than 3 meters.
The capacity indicated by your operating system can be different
q
than the actual capacity of your device. Like most manufacturers
of computer hardware, TrekStor uses the prefixes for units (e.g. 1 GB
= 1.000.000.000 bytes) as prescribed by the International System of
Units (SI). Unfortunately, many operating systems do not comply with
this norm and display a lower capacity because they base their
calculations on the assumption that 1 GB = 230 bytes = 1.073.741.824 bytes.
i Do not move the object as long as the integrated hard drive is active.
Data loss or damage to the hard drive could result. Place the device
on a stable service. Ensure horizontal use.
3) About DataStation® pocket pace 3.0
The DataStation pocket pace 3.0 is an external hard drive with a
USB 3.0-interface for data archiving.

4) Package Contents

• TrekStor DataStation pocket pace 3.0
• USB 3.0 cable
• Operating instructions
EN
10