System Start Up - Canature HT765TO-75 Owner's Manual

12
Key Pad Configuration
SETTINGS This func on is to enter the basic set up informa on required at the
me of installa on.
SELECT Pressing this key allows the user to change the value of each se ng.
DOWN / UP Increase or decrease the value of the se ngs while in the program-
ming mode.
Start-up Instructions
1. Plug the valve into an approved power source.
2. When power is supplied to the control, the screen will display "WAITING PLEASE" while it
finds the service position.
3. Start an Immediate Manual Regeneration. The valve will immediately start moving to the
BACKWASH position.
4. Open the inlet on the bypass valve slightly and very slowly allow water to enter the unit.
(If the water enters too quickly it will push the carbon up into the control valve and get
plugged).
5. Once the unit has filled sufficiently that water is at least equal to the height of the top of
the media shut down the water for 15 – 20 minutes for the carbon to soak. Unplug the
power cable. After the carbon has soaked for the recommended time continue by plug-
ging the power cable back in.
6. Turn the water back on slowly to backwash until water runs clear to drain.
7. Press any button to advance to the RINSE position. Check the drain line flow. Allow the
water to run for 3-4 minutes or until the water is clear.
8. The valve will automatically advance to the SERVICE position after the RINSE cycle is
complete. Open the outlet valve on the bypass, then open the nearest treated water fau-
cet and allow the water to run until clear, close the tap and replace the faucet screen.
9. Program time, date, and number of days between regenerations into controller using Pro-
gramming Instructions
Note : Carbon filters only:
Once the unit has filled sufficiently that water is at least equal to the height of the media
shut down the water for 15 – 20 minutes for the carbon to soak.
After the carbon has soaked for the recommended time continue with installation instruc-
tions.
Additional information for Non backwashing carbon filter.
After soaking, remove the aerator screen from the nearest faucet, run water at this faucet
until all fines (black) is gone from the water.
System Start-Up