Qualcast Lawnraker 32 Operating Instructions Manual page 2

Lawnraker 32 Seite 2 Montag, 23. Februar 2004 2:56 14
Product Specification
Cylinder Mower
Part number
Rated power
Blade width
Grassbox capacity
Weight
Protection class
Serial Number
Intended Use
This product is intended for domestic, lawnraking,
scarifying and for the collection of leaves in the
lawn area.
Introduction
This manual gives instructions on the correct assem-
bly and safe use of your machine. It is important
that you read these instructions carefully.
When fully assembled the machine weighs approx-
imately 10 kg. If necessary, obtain assistance to re-
move from packaging.
Take care when carrying the lawnraker to the lawn,
as the tines are sharp.
Delivered Items
Carefully remove the machine from its packaging
and check that you have all the following items:
– Lawnraker with handle assembly
– Handle bottom
– 2 Bolts (fitted to handle bottom)
– 2 Wing nuts (fitted to handle bottom)
– 2 Pivot pins (fitted to handle bottom)
– 2 Pivot covers (fitted to handle bottom)
– Grassbox
– Operating instructions
When parts are missing or damaged, please contact
the consumer care hotline on (01895) 838782 for assist-
ance. We also have a network of Atco-Qualcast Ap-
proved Service Agents who you can contact for serv-
ice and advice both within and outside the period of
guarantee.
Lawnraker 32
F016 301 0..
400 W
32 cm
31 l
10 kg
/ II
See serial No. 10 (rating
plate) on machine
Operating Controls
1 Handle top
2 Switch lever
3 Safety button
4 Mains plug**
5 Cable restraint**
6 Handle bottom
7 Grassbox
8 Ventilation slots
9 Height of cut lever
10 Serial No (on rating plate)
**Country specific
Not all of the accessories illustrated or described are
included as standard delivery.
For Your Safety
WARNING! SWITCH OFF, REMOVE PLUG FROM
MAINS BEFORE ADJUSTING, CLEANING OR IF CABLE
IS CUT OR ENTANGLED.
THE TINES CONTINUE TO ROTATE FOR A FEW SEC-
ONDS AFTER THE MACHINE IS SWITCHED OFF.
CAUTION - DO NOT TOUCH ROTATING TINES.
Electrical Safety
Your machine is double insulated for safety and re-
quires no earth connection. The operating Voltage
is 230 V ac, 50 Hz. Only use an approved extension
cable. Contact your service agent for details.
Extension cords/leads should only be used if they
comply with H05VV-F or H05RN-F types.
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
For Product not sold in GB:
WARNING: For safety, it is essential that the mains
plug 4 attached to the machine is fitted to the
power supply cable 13 as in Figure B .
The couplings of connection leads must be pro-
tected against splashes and the coupling sockets
on the leads must be made of rubber or coated
with rubber.
Fixing means for the connection leads must be
used.
The connection lead must be inspected for signs of
damage at regular intervals and may only be used
if in perfect condition.
If the supply cord is damaged it must be replaced
by a Atco-Qualcast Approved Service Agent.