Declaration Of Conformity - Qualcast Easi-Trak 32 Operating Instructions Manual

F016 L69 946 Seite 8 Freitag, 19. März 2004 9:15 09

Declaration of Conformity

Measured values determined according to
2000/14/EC (1.60 m height, 1 m distance away)
and EN 28 662.
Typically the A-weighted noise level of the prod-
uct is: sound pressure level 83 dB (A), sound
power level 94 dB (A).
The typical weighted acceleration is 2.5 m/s
We declare under our sole responsibility, that
this product is in conformity with the following
standards or standardization documents:
EN 60 335, EN 836 according to the provisions
of the directives 89/336/EEC, 98/37/EC,
2000/14/EC.
2000/14/EC: The guaranteed sound power
level LWa is lower than 96 dB (A). Conformity
assessment procedure
Annex VI.
Notified body: Stowmarket 12.02
Signature: Director
Guarantee
Atco-Qualcast guarantees this product against
manufacturing defects. We will repair (or re-
place at our option) if a manufacturing defect
occurs within the guarantee period as long as it
has only been subjected to domestic use.
For the purpose of this guarantee, domestic use
means any use of the product on the property
belonging to the purchaser and forming part of
the garden area of his/her dwelling.
The guarantee period is 5 years parts and
2 years labour costs from date of purchase.
To obtain a repair under this guarantee:
• Take the product to an approved service
agent.
• Show your dated proof of purchase.
• Show this guarantee.
The guarantee does not apply if:
i. You cannot provide dated proof of pur-
chase.
ii. The product has been resold by the original
purchaser (this does not apply in the Repub-
lic of Ireland), or has been used under hire.
iii. The product has been modified to change
the manufacturers specifications, or if non
genuine replacement parts have been fit-
ted.
iv. Any previous repair was undertaken by any-
one other than an approved service agent.
v. The fault is due to maladjustment, abuse, ne-
glect or accidental damage.
vi. The fault is due to lack of lubrication or main-
tenance.
vii. Damage to any part, particularly the drive
or cutting mechanism has been caused by
2
.
allowing the product to strike solid objects.
viii. The product develops a fault due to abnor-
mal use.
ix. Failure is due to normal wear. The following
parts are considered as wearing parts. Their
life is dependant on regular servicing and
they are not therefore, normally covered by
the guarantee:
Blades
Bearings
according to
Cables
The cost of routine maintenance of the product
is not covered by the guarantee.
It is in your best interest to follow the Operating
Instructions for your machine, as a properly
cared for product should give many years of ex-
cellent service.
Should you require replacement parts, always
insist on genuine Atco-Qualcast replacement
parts.
through the fitting of parts not made by Atco-
Qualcast is not covered by the guarantee.
Your statutory rights are not affected by this
guarantee.
Your product has been manufactured under an
environmental
when possible, the most environmentally re-
sponsible materials and processes, and with the
potential for recycling at the end of its life. The
packaging is also recyclable.
The plastic components are labelled for cate-
gorized recycling.
When the time comes to dispose of this product
please consider the environment and take it to
a recognised recycling facility.
(Please contact your local authority for location
information).
Any damage caused to the product
Environmental Information
management system using,