Filling With Water; Electrical Requirements; Temperature Control - Morphy Richards Turbosteam Instruction Manual

40655MCZ Turbosteam
damaged cord or if the iron has
been dropped or damaged. To avoid
the risk of electric shock, do not
disassemble the iron, but telephone
Morphy Richards for advice.
Incorrect reassembly can cause a
risk of electric shock when the iron
is used.
• IMPORTANT: When not in use, the
iron should never be left flat on an
ironing board.
• If you drop or severely knock your
iron this could cause internal
damage even if the outside appears
alright. Have it checked by a
qualified electrician.
• To prevent damage to a textile
being ironed, follow the temperature
guide carefully and test the inside of
the hem of the garment.

Electrical requirements

Check that the voltage on the rating
plate of your appliance corresponds
with your house electricity supply
which must be A.C. (alternating
current).
If the socket outlets in your home are
not suitable for the plug supplied
with this appliance the plug should
be removed and the appropriate one
fitted.
WARNING : The plug removed
from the mains lead, if severed,
must be destroyed as a plug
with a bared flexible cord is
hazardous if engaged into a live
socket outlet.
WARNING: This appliance must
be earthed.
Components
⁄ Shot-of-steam button
¤ Spray button
‹ Variable steam control
› Filling hole with cap
fi Spray nozzle
fl Soleplate
‡ Illuminated temperature
control dial
· Water tank
‚ Life long anti-scale
(certain models only)
„ Power on indicator lights -
Auto shut-off indicator
(certain models only)
‰ Filling beaker
17/11/06 9:50 am

Filling with water

1 With the iron disconnected from the
mains supply, set the variable steam
control ‹ to the 'O' position.
Lift up the fill cap › and using the
2
beaker provided fill the iron with
water B.
• One beaker fills the tank (400ml).
3 Replace the fill cap.
4 Always pour out the remaining
water after use.
In hard water areas the use of
distilled or demineralised water is
recommended.
IMPORTANT: Never use battery
topping up fluid or water containing
any substances like starch, or sugar,
or defrosted water from a
refridgerator.
WARNING: When filling the iron
with tap water always use the
beaker provided. Never fill
directly under the tap.

Temperature control

1 Plug in the iron and switch on at the
mains. The 'power on' indicator
lights „ located in the back cover
will illuminate.
2 Set the temperature control dial ‡
to the temperature required, but
don't start ironing immediately. The
indicator light under the control dial
shows that the iron is warming up.
3 After a few minutes the iron will
stabilise at the required temperature
and the indicator light will go out. It
will cycle on-off during operation to
show that the iron is maintaining the
selected temperature.
It is always a good idea to begin with
cool fabrics and work up to higher
settings. An iron heats up quicker
than it cools down so you'll save
time and electricity.
If you do adjust the temperature from
a hot setting to a cooler setting, wait
until the iron temperature has
stabilised before you continue
ironing.
www.morphyrichards.com
Page 3
g
3