Transporting The Hose Powering System - Briggs & Stratton Amplifi 020424 Operator's Manual

6. Attach (long) heavy duty discharge garden hose to pump
outlet (A) inside hose pot. Tighten by hand. Turn on water and
run for 30 seconds to flush system. Turn off water.
NOTICE Use Amplifi brand heavy duty garden hose or equivalent
with 400 psi minimum burst pressure.
7. Uncoil long garden hose and attach opposite end of hose (B)
to spray gun (C). Tighten by hand.
C
B
8. Turn ON water, point gun in a safe direction, release trigger
lock (D) and squeeze trigger to purge pump system and spray
gun of air.
D
Checklist Before Starting Pump Motor
Review the unit's assembly to ensure you have performed all of
the following.
1. Be sure to read Operator Safety and Operation before using
the Hose Powering System.
2. Check for properly tightened hose connections.
3. Check to make sure there are no kinks, cuts, or damage to
hoses.
4. Provide a proper water supply at an adequate flow.
5. Plug electrical cord into a properly grounded electrical source.

Transporting the Hose Powering System

NOTICE Use handle for transporting unit over smooth level
surfaces only. For stairs and uneven surfaces, carry unit using
assistance.
WARNING Lifting hazard. Single person lift could result in
A
1. Remove cover from the Hose Powering System.
2. Slide the transport handle (E) down completely into the slot
as illustrated.
3. Reinstall the cover.
4. Lift handle to transfer the unit's weight to the transport
wheels.
5. Using the handle, move the Hose Powering System to the
desired location.
serious injury. Use assistance when moving or lifting.
Use team lift.
E
7