Operation; How To Start Your Hose Powering System; How To Stop Your Hose Powering System - Briggs & Stratton Amplifi 020424 Operator's Manual

Operation

How to Start Your Hose Powering System

Follow the instructions below in the order presented. If you have
any problems operating your Hose Powering System, please call
the Hose Powering System helpline at (800) 743-4115.
1. Using the transporting handle, place Hose Powering System
near an outside water source capable of supplying water at
a flow rate greater than 6 gallons per minute (22.7 l) and no
less than 30 PSI (2.07 BARS) at the Hose Powering System
end of garden hose. DO NOT siphon supply water.
2. Connect shorter inlet garden hose to water inlet.
3. Check that longer heavy duty discharge garden hose is tightly
connected to spray gun. See Connect Hoses and Water
Supply for illustrations.
NOTICE DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
4. Turn ON water, point gun in a safe direction, disengage
trigger lock and squeeze trigger to purge pump system of air.
5. Remove any dirt or foreign matter from spray gun outlet and
rotate multi nozzle spray head to desired spray pattern. See
How to Use the Spray Gun Nozzles for details.
6. Press the master ON/OFF switch (A) to the OFF position (O).
A
7. Plug electrical power cord into an electrical circuit rated
for 120 Volts AC at 15 Amps that is properly installed and
grounded in accordance with all local codes and ordinances.
The green indicator on the GFCI should appear.
NOTICE The green indicator must be visible for the Hose
Powering System to operate.
8. Press TEST button (B). The green indicator should disappear.
B
D
9. Press RESET button (C). The green indicator (D) should
illuminate.
NOTICE DO NOT use the Hose Powering System if above test
fails.
10. Press the master ON/OFF switch (A) to the ON position (I).
11. Point gun in a safe direction, disengage trigger lock and
squeeze trigger. The Hose Powering System motor will start
and stop as spray gun trigger is depressed and released (only
when power nozzles are selected).
NOTICE A short delay for the pump to turn on after the trigger
is squeezed is normal. A longer more flexible hose will result in a
longer starting delay.
The Hose Powering System is now ready for use. Instructions for
use of the supplied accessories are given later in this section.
NOTICE It will take a few seconds for the water to pressurize the
spray gun.

How to Stop Your Hose Powering System

The Hose Powering System motor runs only when the trigger
is engaged and a power nozzle is selected. To stop the Hose
Powering System and turn off the motor:
1. Release spray gun trigger.
2. Press the master ON/OFF switch to OFF position (O).
NOTICE Releasing the trigger will shut off the motor but does
not shut off electrical power to the unit.
3. Turn off water supply.
4. ALWAYS point spray gun in a safe direction and squeeze
spray gun trigger to relieve built up pressure in the unit.
NOTICE Spray gun traps high water pressure, even when motor
is stopped and water is disconnected.
5. Engage trigger lock.
6. Disconnect GFCI plug from outlet and coil power cord.
7. Coil discharge hose.
8. Flush detergent bottle by removing it from spray gun and
pouring out all remaining solution.
9. Rinse detergent bottle out with fresh clean water.
10. Reinstall detergent bottle onto spray gun. Store discharge
hose, power cord, spray gun and handle in hose pot.
11. Install cover on unit.
C
9