Other Tips; Applying Detergent; Hose Powering System Rinsing - Briggs & Stratton Amplifi 020424 Operator's Manual

Other Tips

• Water large plant beds with power shower.
• Use gentle shower for delicate plants or single planters.
• Power Jet allows max performance on second stories.
• A short delay for the pump to turn on after the trigger is
squeezed is normal. A longer more flexible hose will result
in a longer starting delay.

Applying Detergent

WARNING Chemical Burn Hazard.
Chemicals could cause burns resulting in
death, serious injury and/or property damage.
• Always wear indirect vented (chemical splash) safety goggles
marked to comply with ANSI Z87.1 when using chemicals.
• DO NOT substitute safety glasses or dry-condition goggles
for indirect vented safety goggles.
• DO NOT use caustic liquid with Hose Powering System.
• Use ONLY pressure washer safe detergents/soaps. Follow all
manufacturers instructions.
Your Hose Powering System is equipped with Detergent on
TM
Demand .
To apply detergent, follow these steps:
1. Review use of multi nozzle as shown in How to Use the Spray
Gun Nozzles.
2. Prepare your detergent solution as required by job to be
performed.
3. Rotate sprayer bottle (A) 90 degrees counter-clockwise and
pull from spray gun.
B
A
4. Fill bottle with detergent solution.
5. Place suction hose back into sprayer bottle.
6. Replace bottle (A) onto sprayer body and rotate 90 degrees
clockwise until it clicks into place.
7. Squeeze trigger (B) to spray water only. Press the red button
(C) to pump detergent into the water stream.
NOTICE Trigger must be pressed along with the red button to
apply detergent.
8. Apply detergent to a dry surface, starting at lower portion
of area to be washed and work upward using long, even,
overlapping strokes.
9. Allow detergent to "soak in" for 3-5 minutes before washing
and rinsing. Reapply as needed to prevent surface from
drying. To prevent streaking, Do Not allow detergent to dry on
surface.

Hose Powering System Rinsing

Starting at top of area to be rinsed, work downward using long,
even, overlapping strokes.
Other Cleaning Tips
• NEVER leave the Hose Powering System unattended while
it is plugged into an electrical outlet and while water is
supplied to the equipment.
• If you have the nozzle too far away from the surface being
washed, the cleaning may not be as effective.
C
11