How To Use The Spray Gun Nozzles; Sprayer Removal/Reassembly; Usage Tips - Briggs & Stratton Amplifi 020424 Operator's Manual

How to Use the Spray Gun Nozzles

You should now be familiar with how to START and STOP your
Hose Powering System. If not, please refer to the previous
section to familiarize yourself with STARTING and STOPPING the
system before continuing.
The information in this section will instruct you how to adjust
the spray pattern and to apply pressure washer safe detergents/
soaps.
The selector nozzle allows you to switch between five different
spray pattern nozzles. Spray patterns can be changed while
pressure washer master switch is in the ON (I) position; however,
make sure spray gun trigger safety lock is engaged. The spray
patterns vary as shown below.
Multi Nozzle
D
C
B
A
The Amplifi Sprayer has a multi nozzle spray head.
A Power Jet — High pressure line of water.
B Power Shower — High pressure cone of water.
C Power Fan — High pressure fan of water.
D Gentle Fan — Low pressure fan of water
E Gentle Shower — Low pressure cone of water.
Spray Patterns
A B
The Power nozzles are designed to turn the pump ON for more
water pressure and flow, and the Gentle nozzles are designed to
turn the pump OFF for standard garden hose pressure.
To use a specific nozzle
1. Rotate the spray head (A) so the desired nozzle is at the top
of the sprayer and is aligned with the arrow (B). Make sure
the spray head clicks into place.
B
A
10
E
C D

Sprayer Removal/Reassembly

1. The sprayer assembly (C) can be separated from the trigger
assembly (D) by pressing the two buttons (E) and twisting the
trigger assembly 90 degrees in either direction, then pulling
them apart.
D
2. Reattach the trigger assembly (D) to the sprayer assembly
(C) by pressing the two buttons (E) and inserting the trigger
assembly into the sprayer assembly at a 90 degree angle.
D
3. Then rotate the trigger assembly to the position shown below.
Release the two buttons (E) to lock the assemblies into
position.
E
NOTICE The trigger can be used with other Amplifi accessories.
Please visit www.amplificleaning.com for additional information.

Usage Tips

• If you position spray nozzle too close to cleaning surface,
especially using high pressure mode, you may damage
surface being cleaned.
• For bucket and pool filling, remove the sprayer assembly (C).
E
C
F
E
C
F
www.amplificleaning.com