Advertisement
Available languages
Available languages
7. Switch on the quick start system by turning the main switch (1) and wait for 3 to 5 minutes.
8. Switch the vehicle ignition to the „ON" position.
9. Switch the ignition to the start position for no more than 5 to 6 seconds.
10. If the vehicle or boat engine does not start, wait at least 3 minutes before re-trying.
11. When the engine is running, disconnect the black clamp first and return the cable to its
stored position on the jumpstart system.
12. Disconnect the red clamp and return the cable to its position on the system.
13. Recharge the Jump Start system as soon as possible. You can only perform an
emergency start if the quick start system is fully charged.
14. The quick start system is not suitable for starting completely discharged batteries!
To use your Jump Start System to power appliances:
Lift up the cover of the cigarette lighter receptacle (4).
1.
Insert the cigarette lighter plug of the appliance into the cigarette lighter receptacle and
2.
connect to your 12V-tool.
USB output
At the USB port (6), small loads with a USB plug may be operated. The USB port delivers 5 Volt
with up to 1000 mA and is not a data port. With the switch (8), the voltage on the port can be
switched on or off. The operating status is indicated by the green LED.
Compressor Operation
1. If inflating a tire, place the hose connector on the tire valve stem and press the connector
lever down to lock in place.
2. If inflating a ball, air mattress or other item, place the inflation needle or plastic adapter (17)
into the hose connector end, press the connector lever down to lock in place.
3. Turn the compressor power switch (13) to the „ON" position.
4. Note: Do not over-inflate item. Check pressure gauge (12) and stop inflating, when
adequate pressure is reached.
5. Only run the compressor for 10 minutes at a time. If more air is needed, wait 10 minutes for
cooling down, before using again.
Recharging
This unit is rechargeable by either the re-charging adapter or by use of a vehicle 12 VDC
cigarette lighter output socket. It is recommended that the battery is kept fully charged at all
times. (Caution! Put the main switch (1) in the "OFF" position.)
If the battery is left in a low charge state, it could shorten battery life. The time required to
recharge the battery depends on the number of previous battery jump starts .To check and see
if the battery is low, press the red button (11). When the LED (10) flashes green, the quick start
system is sufficiently charged.
GB - 10
Advertisement
