Advertisement
may be as frequent as 3-6 months. To replace the filter, follow the instructions above to remove and
empty the dust bin. With the dust bin removed, reach underneath the Filter Cartridge and unscrew the
filter retaining nut. Remove the nut and washers and pull the filter downward then forward out of the
unit. Replace the filter with a new filter cartridge then reverse removal instructions for proper installation.
Filter Cartridge re-order P/N 97001.
NOTE:
Be sure to replace the rubber washer FIRST and the metal washer SECOND. Securely fasten
the filter retaining nut. Improper installation may cause dust to pass into the air.
4. Electrical Protection - The StoneVac II is protected by a circuit breaker. If the unit is plugged in and
does not operate, check to see if the circuit breaker was activated by inspecting it on the back of the unit
where the power cord enters the unit. If the circuit breaker was activated, push the button in the center
to reset it. If the unit still does not operate, contact your dealer or call the factory at 1-800-VANIMAN for
technical assistance.
RECOMMENDED USAGE
1. Individual work station (2½" hose) or dry model trimmer dust collection for trimming or grinding Die Stone.
While the StoneVac II was designed specifically for Die Stone, it will also handle other dust developed at
the same workstation such as alloy, porcelain, and acrylic.
2. The StoneVac II can be used with abrasives or micro-blasters. If used for this application, it is important
that the filter be serviced or replaced regularly. Additionally, Vaniman's Pre-Filter/Accumulator helps capture
abrasive before it reaches the dust collector, increasing the life of the filter.
140 N. Brandon
P.O. Box 74, Fallbrook, CA 92088
STONEVAC II
120V
1-800-VANIMAN (826-4626)
STONEVACII-I-09/14 Page 2
Advertisement
