Advertisement
Single Headset Base
1.When the base station is first powered, the green LED labeled POWER on the
bottom left of the front panel will illuminate steadily. The single LINK yellow LED
will either stay unlit, indicating that no headsets have been previously paired to the
base, or will start flashing rapidly, indicating that a headset has been previously
paired to the base station
2.Press and hold the pairing button in the bottom right corner of the base station
for approximately 5-7 seconds. The LINK LED will start flashing slowly to indicate
that the base station has been placed in pairing mode. Once the base station is
placed in pairing mode, the user has approximately 15 seconds to place the
headset in pairing mode.
3.Place the headset in pairing mode; refer to the UHW/ FHW series user's manual
for information regarding how to put the headset in pairing mode. The red and
green LEDs on the headset will alternate rapidly to indicate that the headset is in
pairing mode.
4.After about 5-7 seconds, the green LED on the headset and the yellow LINK LED
on the base station's front panel will flash rapidly for two seconds then turn on
steadily to indicate that a link has been established between the headset and the
base. At this point, full duplex audio communication between the headset and the
base station is enabled.
4
PAIRING
WIRELESS BASE
POWER
INTERCOM
Single Headset Base Station
5
.
LINK
PAIR
Advertisement
